Safety Signs; Product Identification Label; Main Components - Stiga SP 386 Manual De Instrucciones

3.1.3 User types
This machine is intended for use by
consumers, i.e. non-professional operators.
The machine is intended for "DIY" use only.

3.2 SAFETY SIGNS

The machine has various symbols on it
(Fig. 2). They are used to remind the operator
of the behaviour to follow to use it with
the necessary attention and caution.
Meaning of symbols:
WARNING! DANGER! Failure to
use this machine correctly can be
hazardous for oneself and others
WARNING! Read the instruction
manual before using the machine.
Anyone operating the machine
under normal conditions for
continuous daily use may be
exposed to a noise level equal
to or exceeding 85 dB (A). Wear
ear protectors, safety goggles
and a protective helmet.
Wear gloves and safety boots!
BEWARE OF KICKBACK!
Kickback is the rapid and
uncontrollable backward motion
of the chain saw in the direction
of the operator. Always work in
complete safety. Use chains with
safety links that limit kickback.
Never hold the machine with one
hand! Hold the machine fast with
both hands to control the machine
and reduce the risk of kickback.
IMPORTANT Any damaged or illegible
decals must be replaced. Order replacement
decals from an authorised assistance centre.

3.3 PRODUCT IDENTIFICATION LABEL

The product identification label provides
the following data (Fig. 1):
1. Sound power level
2. Conformity marking
3. Year of manufacture
4. Type of machine
5. Serial number
6. Name and address of Manufacturer
7. Emission number
8. Article code
Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
IMPORTANT Quote the information on
the product identification label whenever you
contact an authorized service workshop.
IMPORTANT The example of the
Declaration of Conformity is provided
on the last pages of the manual.

3.4 MAIN COMPONENTS

The machine is made up of the following
main components (Fig. 1):
A. Engine: supplies the drive power
to the cutting means.
B. Front handgrip: support handgrip
located on the front of the chain saw. This
should be grasped using the left hand.
C. Rear handgrip: support handgrip located
on the rear of the chain saw. This should be
grasped using the right hand. This handgrip
is fitted with the main throttle controls.
D. Front hand guard: protection device
seated between the front handgrip and
the toothed chain, to protect the hand
against injuries should it slip off the
handgrip. This guard is used as a device
to trigger the chain brake (par. 5.7).
E. Rear hand guard: protection device
seated in the lower right section of
the rear handgrip, to protect the hand
from the chain saw should it break
or disconnect from the guide bar.
Guide bar: supports and
F.
guides the toothed chain.
EN - 5