Specifications - LG WD4370HVA El Manual Del Propietario

Problem
Wrinkling
Power is not turned on
The door does not open when
the cycle pauses or finishes
The wash cycle time is longer
than usual
It is musty or moldy in the tub
Banging noise when washer
is filling with water (Water
Hammer)
Strange odors coming from
washer

SPECIFICATIONS

Model WD4370HVA
Description
Electrical requirements
Dimensions
Net weight
Wash capacity
Max. Watt
Max. spin speed
Max. water pressure
Possible Causes
y Did you remove the load immediately after it finished?
y Did you overload the tub?
y Did you reverse the hot and cold water inlets?
y Is the power cord plugged in properly?
y Has a house fuse blown, a circuit breaker tripped, or a
power outage occurred?
y Is the temperature in the tub too high?
y Is the water level in washer high?
y Is the washing machine overloaded? Are other options
added to the wash cycle?
y Has the incorrect detergent been used?
y Did you clean the tub periodically?
y Plumbing in the home moves or flexes when the water
valves in the washer shut off.
y Household water supply pressure is very high.
y Heater in dryer.
y First time using washer
y Buildup of dirt on gasket or drum, dirty or clogged drain
pump filter, kinked or clogged drain hose
Front loading washing machine
120 V~, 60 Hz
686 mm(W) x 767 mm(D) x 982 mm(H) / 1295 mm (D, door open)
96 kg(211lbs)
20,0 kg (44 lbs) / 9,0 kg (20 lbs)
Washer : 1050W / Dry : 1200W
1300 rpm max
100 – 1000 kPa (1.0-10.0 kgf/cm 2 )
SPECIFICATION
Solutions
y Remove the load immediately after it finishes.
y Do not overload the tub.
y Hot water rinse can cause garments to wrinkle. Check
the inlet hose connections.
y Make sure that the plug is secured in a grounded
3-prong, 120 V (60 Hz) outlet.
y Reset the circuit breaker or replace the fuse. Do not
increase the fuse capacity. If the problem is a circuit
overload, have it corrected by a qualified electrician.
y The washing machine has a safety lock built into the
door to prevent burning. Leave the door closed and wait
until the door lock icon disappears from the display.
y Allow the washer to complete the programmed cycle, or
Press the SPIN button.
y This is normal. The washing machine automatically
adjusts the cycle time for the amount of laundry, water
pressure, water temperature, and other operating
conditions.
y See page 30, clean the inside and outside of the washing
machine periodically.
y Water hammer is not caused by a defect in the washer.
Install water hammer arrestors (purchased separately at
hardware or home improvement store) between the fill
hose and the washer for best results.
y Adjust household water supply regulator to a lower
pressure or contact a plumber to have a regulator
installed.
y During the initial phase of operation, lint from laundry
can settle on the heater and cause odors. This is normal
and will not affect performance.
y Smell comes from the rubber attached to the washer
door. It will eventually dissipate after first couple of wash
cycles.
y Periodically clean the gasket. Mold and foreign
substances inside the gasket may produce mildew or
musty smells.
y Clean the drain pump filter regularly. Foreign substances
on the drain pump filter may produce mildew or musty
smells.
y If the drain hose is not installed properly, the odor may
be emitted because of a backflow of drainage into the
tub. Make sure that the drain hose is not kinked or
clogged.
37