Front Runner LASS026 Manual Del Usuario página 37

installation of slimline ii tray cont...
( )
Slide an End Cap (Item 3) into the ends of
C
Track and secure in position using the
M3 x 6 Self Tapping Screw (Item 1).
( ) Grab your friend and with one of you on each side of the Rack, flip it end over end so that the bolts are
D
facing down. Approach the vehicle from the rear lifting the Rack above the Legs. Slowly lower the Rack
lining up the bolts in the Rack with the holes in the Legs. You may need to adjust the position of the Legs.
Position the Rack front to back and fasten the bolts securing the Legs to the Tracks (From Step 2B).
Place the M8 Flat Washers and M8 Nyloc Nuts supplied with the Universal Load Bed Legs onto the Bolts
securing the Rack to the Legs and hand tighten. Center the Rack Left to Right. Apply weight/downward
pressure to the Rack so that the Slats are sitting flush onto the Legs and fasten the M8 Nyloc Nuts
securing the Rack to the Legs. Place a M8 Nut Cap supplied with the Universal Load Bed Legs over each of
the M8 Nyloc Nuts.
Congratulations, you have completed your installation. Take a step back and admire your work. Good Job!
TRBU001 / KRLBUNI1_REV_A01
4