Usb Charging; Checking Battery Status; Jumpstarter - Wagan Tech iOnBoost Slim Manual De Usuario

iOnBoost Slim by Wagan Tech
™
CHARGING THE IONBOOST
This product may arrive partially charged from the manufacturer� It is recommended to
fully charge the unit immediately after purchase and before using for the first time� Prior to
charging the unit, read and understand all instructions in this manual�
In order to prolong the life of the iOnBoost, be sure to fully recharge the unit after each use and
every 3 months even if the iOnBoost has not been used.

USB CHARGING

1. Plug the micro USB cable into the micro USB input port on the iOnBoost.
2. Plug the other end into a USB power source such as a USB wall charger or computer (not
included). For charging in your vehicle, use the included USB vehicle adapter.
a. The blue battery status indicator lights will illuminate while the unit is charging.
3. Fully charge the unit (around 2 hours). Charging is complete when all battery status
indicator lights illuminate solid.
4. When charging is complete, unplug the USB cable.

CHECKING BATTERY STATUS

1. Turn on the master switch
2. Wait 3 seconds
3. Press the Power button once
4. Turn off the master switch when finished.

JUMPSTARTER

JUMPSTART WARNINGS
Failure to follow these instructions may cause damage or explosion�
NOTE: Cranking an engine produces an accumulation of explosive gas above and near the vehicle
battery. Before any attempt to jumpstart a vehicle battery, make sure explosive gas is dispelled
from the area. Use a cardboard or newspaper fan to wave the gases away from the battery for a
few minutes. Do not use plastic or metal sheet—they can produce sparks and ignite the gas.
• Jumpstart cables connected to iOnBoost are ALWAYS live! Never allow the clamps to touch
together or contact the same piece of metal.
• Do not attempt to jumpstart your vehicle when iOnBoost is below 75% charge (observe
battery status indicator lights on the unit—75%=3 solid lights).
• Only use this jumpstarter with 12 Volt negative–grounded systems. Most US vehicles have
negative (-) battery terminals connected to the vehicle frame. (Negative – Ground). Check
the negative battery terminal connecting wire to make sure it also connects to the frame.
• Make sure the jumpstarter clamps get connected to correct polarity (red to positive battery
terminal, black to vehicle frame for negative ground systems when jumpstarting).
6
®
www.wagan.com