Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 4: INSTALL NEW FILL VALVE
A:
ATTACH REFILL CLIP TO OTHER
END OF REFILL TUBE
B:
INSERT FILL VALVE
Position refill tube to face flush valve
making sure fill valve parts do not
interfere with lever arm.
Fill Valve
Refill Tube
Overflow
Pipe
Lever Arm
C:
ATTACH REFILL CLIP TO
OVERFLOW PIPE
Note: If refill tube is too
long to fit inside tank with
lid closed, remove refill tube
from fill valve refill port, cut
tube, and reattach to port.
D:
INSTALL LOCKNUT
Screw locknut to the right
(counterclockwise) onto fill valve
shank (below tank).
*Hand-tighten only.
DO NOT OVER TIGHTEN.
* Over tightening may crack the fill valve or tank causing flooding. Make sure the float cup
does not touch the tank walls or tank lever and flush valve.
6
TOP
DOWN
VIEW
Scissors
(Optional)
RIGHT
STEP 5: FINISHING STEPS
A: ATTACH WATER SUPPLY
CONNECTOR TO FILL VALVE
Twist to the right
(counterclockwise)
*Hand-tighten only.
DO NOT OVER TIGHTEN.
B:
TURN ON WATER
Check for leaks.
(Go to www.Fluidmaster.com/support
for leak solutions.)
C: WATER LEVEL
After the tank stops filling, water level should fill the tank to
roughly ½ inch below top of overflow pipe to ensure a
proper flush. (Does not need to be exact.)
**
Lever Hole
*
Over tightening may damage fill valve or coupling nut, potentially causing flooding. Make sure
the float cup does not touch the tank walls or tank lever and flush valve.
**
The top of the overflow pipe must be a minimum of 1" below tank lever hole.
RIGHT
TURN
COUNTER-
CLOCKWISE
Top of
Overflow Pipe
1/2"
Water Level
Overflow Pipe
7
Publicidad
