How To Use - VORAGO HPB-201 Guía Rápida

HOW TO USE

Please plug Micro USB into headphone charging port and
connect the other side with USB wall charging adapter or
computer. LED indicator turns red while charging, and turns
blue when fully charged. (Headphone reminds you battery low
every 15 minutes when the battery power is below 10%)
3.5mm jack for AUX mode don't need the headphones to be
charged. Connect AUX cable to mobile phone or computer. The
headset must be power offto enter AUX mode.
Functional Operation
Power on: Press and hold button 3 seconds under the device
is off (the red and blue led light will flash, you will hear voice
promote"power on and pairing,"at the same time),enter to the
pairing mode freely.
Play/pause: Press button to pause when it is
Play/pause: Press button to pause when it is playing, then press
again to play.
Volume up: One click
Volume down: Click button
Previous Track: Long press button
Next Track: Long press button
Answer incoming call: Click button
Hang up the phone: Click button
Reject incoming call: Press button 2 seconds
Power off: Press and hold button 4 seconds when headset is
in standby or working mode. (voice prompt "power off" with 2
seconds LED light)
BT CONNECTION
1. Press and hold the MFB for 3 seconds until the headphone
powers on and enters pairing mode automatically after 5s. LED
indicator flashes blue and red alternately. ( Headphone powers
off after 5 minutes if no Bluetooth connected)
2. Activate Bluetooth on your phone ( or other devices) and set
it to search for new devices.
iPhone Settings > Bluetooth > On
Android Settings > Bluetooth > Search for devices
NOTE: Menus may vary by different
3. Select "HPB-201"
If necessary, enter four zeros (0000) for pass code and accept
connection. Once successfully paired, the headphone LED
indicator flashes blue.
• Wired connection：Use the included audio cable to connect.