Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SD CARD
• Formart must be FAT32.
•It would into TF mode once insert TF card：then indentify music
automaticlly. Long press music key 1s to switch Bluetooth
mode, long press again to switch TF mode .Endless loop.
TROUBLESHOOTING
1. The indicator blinks red quickly (interval 2S) or continuously?
It means that the battery is low. Please charge the headphone
as soon as possible!
2. Cannot boot?
It means that the battery is low. Please charge the
headphone as soon as possible!
3. No indicator when charging?
There may be no charge instructions for the first few
minutes If the battery is completely exhausted or charged
for the first time after not being used for a long period, but
the indicator glows red to indicate the charging state after
a while.
4. Bluetooth headphone is without sound?
• ： Make sure Bluetooth headphone is switched on.
• Make sure the music sound output is the Bluetooth device
(HPB-201).
• ： Make sure the Bluetooth headphone and the phone are
paired and connected successfully.
• ： Make sure the distance between Bluetooth headphone and
cellphone is no more than 10 meters/ 32.8ft away.
• ： Make sure your phone is within the range of signal and
without external interference.
• ： Make sure your phone is not connected to other devices.
• Verifica que tu equipo transmisor se encuentre encendido y
funcionando.
• Verifica que en tus audífonos y tu equipo transmisor este
habilitado el transmisor BT.
5. There is no sound：in the headphone when in wired ：：：：
：connection?
： Make sure you insert correct 3.5mm audio cable and
connect successfully. Note that the headphone buttons and
microphones do not work when wire the headphone.
Make sure cell phone is in normal working condition and
without damage.
6. Bluetooth connection is not successful?
Make sure both the headphone and cell phone Bluetooth
devices are turned on.
Make sure the headphone enters Bluetooth pairing mode
(the indicator blinks blue)
Try to ignore the previous connected Bluetooth devices and
empty the Bluetooth list. Search the device again.
Publicidad
Tabla de contenido
