Option Cycle
Lavado programado (Delay Wash)
You can set a time delay so that the washing machine
will start automatically and finish after a specified time
interval.
1
Press the Power button.
2
Select a washing programme.
3
Press the Lavado programado button and set
time required.
4
Press the Start/Pause button.
NOTE
• The delay time is the time to the end of the
programme, not the start. The actual running time
may vary due to water temperature, wash load
and other factors.
Vapor (Steam)
Steam Wash features enhance washing performance
with low energy consumption.
1
Press the Power button.
2
Select steam course.
3
Press the Vapor button.
4
Press the Start/Pause button.
Steam Wash
• For heavily stained clothes, underwear, or baby
clothes.
• Do not use Steam Wash for delicates such as wool,
silk, and easily discoloured clothes.
Añadir prendas (Add Item)
Use this function to add loads or remove the foreign
material.
1
Press the Añadir prendas button.
2
Close the door after add loads or remove the
foreign material. (e.g. coin or pin etc.)
3
Press the Start/Pause button.
• Results when choosing Add Item during cycles.
- When the tub is spinning : Tub stops and Door Lock
is off.
- When water temperature in the tub is higher than
45°C : Add Item is not available with short warning
sound for safety.
- When lots of water is in the tub : Door Lock is off
after draining by safe water level.
NOTE
• Open the door when Door Lock is off after
checking the safety.
• Add Item doesn't work when Tub Clean course is
in progress for safety.
• Put the laundry into the tub completely. Laundry
caught in between door closing part can damage
door packing (rubber part) and might cause
failure.
27