Specifications For Models With Oven; External Cleaning; 10. Seasonal Stoppages - Bronpi VOLGA 130X40 Instrucciones De Instalación, Uso Y Mantenimiento

9.4

SPECIFICATIONS FOR MODELS WITH OVEN

(Only models Everest and Everest Visión)
Over time and with the use, this model can create soot deposits in the
external parts of the oven. These deposits can obstruct the draw and
cause a malfunction of the insert. For this reason, it is important to remove
them through a register that is hidden under the logo of the oven door. It is
necessary to unscrew the logo and use the hole in order to proceed with the
cleaning (see drawing D45).
When you are cleaning the oven, please be careful and do not
use aggressive products because they can wear down the
paint and too much water can oxidise it.
In the model Everest Visión the cleaning register is hidden under the door. To
cleaning it, the cover must be unscrewed and the register will appear (see
drawing D46).
9.5

EXTERNAL CLEANING

Do not clean the external surface of the insert with water or abrasive products because they may damage the fireplace. Use a feather duster
or a rag a bit wet.

10. SEASONAL STOPPAGES

After cleaning the chimney and the insert by removing the ash and other residues, close all doors and regulators.
It is recommended to clean the chimney at least once a year. Meanwhile, check the joints because if they are not in good condition (they do
not adjust to the door), they do not guarantee the proper operation of the insert! For this reason, it would be necessary to change them. You
can find this spare part in the same Bronpi distributor where you bought your insert.
If there is humidity in the place where the fireplace is installed, put absorbent salts inside the equipment. Protect the internal parts with neutral
vaseline in order to keep the appearance along the time.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS 40
D45
D46
INSERTS