Motor; Motor Reset Switch - Porter Cable PXCMLC1683066 Manual De Instrucciones

DANGER
I
result in a risk of electric shock. If repair or replacement of the
cord or plug is necessary, do not connect the grounding wire to
either flat blade terminal. The wire insulation having an outer
surface that is green with or without yellow stripes is the
grounding wire.
This product is for use on a nominal 115 or 230 volt circuit. A cord with a
grounding plug, as shown here, shall be used.
Make sure that the product is connected to an outlet having the same
configuration as the plug (see Fig. 4). No adapter should be used with this
product.
Check with a licensed electrician if the grounding instructions are not completely
understood, or if in doubt as to whether the product is properly grounded. Do
not modify the plug provided; if it will not fit the outlet, have the proper outlet
installed by a licensed electrician.
FOR PERMANENTLY CONNECTED MODELS OR MODELS SHIPPED
WITHOUT POWER CORD: This product must be connected to a grounded
metallic, permanent wiring system, or an equipment grounding terminal or lead
on the product.
115V
115 VOLT
15 AMP
Plug
MOTOR RESET SWITCH AND WIRING
WARNING
I
Ensure that all guards and shrouds are in place before
pressing the reset switch to restart the motor.
If the motor shuts down because of overload, wait 10–15 minutes so the motor
can cool down, then press (NEVER force) the reset switch (see A) to restart the
motor (see Fig. 5).
Improper installation of the grounding plug can
Fig. 4
Grounded Outlet
Box
Grounded Outlet
Grounding Pin
10- ENG
230V
230 VOLT
15 AMP
Plug