Front Runner FAJL002 Manual Del Usuario página 11

2 PREP FOR RACK INSTALL (FULL RACK)
2.1
10
2.2
2.3
12
13
14
15
15
FAJL004_REV_A01
1
9
2
7
7
Recess
8
2
13mm
13mm
4
3
T40
Recess
4mm
5mm
6
5
3
Assemble the LH Front Support Arm (Item
1) and the LH Pillar Bracket (Item 10)
using two M8x16 Hex Head Bolts, two M8
Flat Washers and two M8 Nyloc Nuts (Item
9, 2 & 3). Finish of by placing two M8 Nut
Caps over the M8 Nyloc Nuts.
Do this with th RH Front Support Arm (Item
11) and the RH Pillar Bracket (Item 1).
Using a T40 Torx Wrench, remove the four
bolts holding the Corner Cover in place.
Place two Spacers 19x12x15 (Item 7) into
the two top recesses as shown.
Do this on both sides of the vehicle.
Carefully place the Front Support Arm
onto the two top Spacers, aligning the
holes in the Pillar Bracket with the holes
on the vehicle. Loosely assemble the
Support Arm assembly to the vehicle
using M6x50 Button Head Screws, M6
Spring Washers, M6 Flat Washers and
M6 Large Flat Washers (Items 12, 13, 14
& 15).
Place two Spacers 19x12x12 (Item 8)
into the two side recesses shown in 2.2,
between the Front Support Arm and the
Corner Cover.
Loosely assemble the side of the
Support Arm using M8x30 Button Head
Screws, M8 Spring Washers and M8 Flat
Washers (Items 5, 6 & 2).
Make sure the Support Arms are
straight, using the door shut line as a
guide. fully tighten the M8 Button Heads
and then the M6 Button Heads on top.
© 2020 FRONT RUNNER VEHICLE OUTFITTERS
13mm