Model 1819 | Owner's Manual |
Care & Maintenance
Section 03
CLEANING THE BURNER ASSEMBLY
Unit burners vary, however these instructions apply to all units. Clean
burner assembly and check burner for damage. If any large cracks or
holes are found, replace burner.
S T E P 0 1
griddle top.
28
Turn gas OFF at control knobs and gas supply. Remove
S T E P 0 2
Carefully detach and
remove the burner.
S T E P 0 3
Run a narrow bottle
brush through each burner
tube several times. (Do not use
wire brushes)
Additional Methods Include:
a Run a stiff wire bent into a small
hook through each burner tube
several times.
b Use an air hose to force air into
burner tube and out burner ports.
Check that air blows through each
hole. (Wear eye protection)
S T E P 0 4
Brush entire outer
surface of burner to remove grime.
S T E P 0 5
Clean any blocked ports
with stiff wire such as an open
paper clip. Then, carefully replace
burners and reattach. Burner
tubes must be reengaged with the
valve openings.
BURNER FL AME CHECK
MATCH LIGHTING
INSTRUCTIONS
01. Light burners and rotate knobs
from high to low. When knob is
Before beginning, check for gas
at high, flames should be larger
leaks. (Please reference the
than when knob is at low.
Leak Test Instructions in the Fuel
chapter.)
02. Perform burner flame check
by looking below griddle top
01. Ensure control knob is in
on the side of unit to view
OFF position.
burners below.
02. Remove griddle top.
03. Always check burner flame
03. Light a match (or long lighter)
before use.
no shorter than 11 inches long.
If there is a sudden drop or low
Place the flame on the right or
flame issue, please reference the
left side of the burner.
Troubleshooting chapter.
04. Push in and turn the control
For additional support, see youtube.
knob to the HIGH position.
com/blackstonegriddles
Ensure burner lights and
stays lit.
Care & Maintenance
| Owner's Manual | Model 1819
Healthy flames might have a few
flickers of yellow color ❶, then a
dark blue color ❷, followed by a
vibrant blue by the burner tube ❸.
❶
❷
❸
29