Publicidad
Idiomas disponibles
Idiomas disponibles
1. GENERAL CHARACTERISTICS
RHT160
– Application range: suitable for piercing holes in mild steel and copper strip (Tab. 1) at a maximum
distance of 30 mm (1.2 in.) from edge (Fig. 1).
– Dimensions: length ........................................................................................................240 mm
width ..........................................................................................................153 mm
– Weight:
6,5 kg (14.3 lbs)
RHT160-60N
– Application range: suitable for piercing holes in mild steel and copper bars (Tab. 1) at a maximum
distance of 60,7 mm (2.39 in.) from edge (Fig. 1).
– Dimensions: length ........................................................................................................240,5 mm (9.47 in.)
width ..........................................................................................................181,5 mm (7.1 in.)
– Weight: ................................................................................................................................9,3 kg
– Max operating pressure: .............................................................................................700 bar
– Oil necessary (displacement): ....................................................................................36 cm
– Force developed: ............................................................................................................165 kN
mm (inch)
TABLE 1 –
Hole diameter
Max thickness Strip
in copper
Max thickness Strip
in steel
Die/Set
2. INSTRUCTIONS FOR USE
2.1) Setting
The head is equipped with a "self-lock" quick male coupler suitable for connection to a hydraulic,
pneumatic or electrical pump from the Cembre range. Select the appropriate punch/die set (see
Table 1) and insert it in the head following the instruction at § 4 and 5.
2.2) Punch advancement
Position metal strip (b) between the punch and the die; operate the pump to advance the punch
(90) until the metal strip is lightly held against the die (91). Halt the pumping operation and adjust
the positioner (10) to give 1 mm clearance from the metal strip.
3
HYDRAULIC PIERCING HEAD
RHT160 and RHT160-60N
6,5
8,5
9
(0.25)
(0.33)
(0.35)
(0.41)
10
(0.39)
RT6,5 RT8,5 RT9 RT10,5 RT11 RT13 RT13,5 RT14 RT15 RT17 RT19 RT21
(Ref. to Fig. 1)
10,5
11
13
13,5
(0.43)
(0.51)
(0.53)
10
(0.39)
(0.35)
3
14
15
17
(0.55)
(0.59)
(0.67)
9
8
7
(0.31)
(0.27)
ENGLISH
(9.4 in.)
(6.0 in.)
(20.3 lbs)
(10,000 psi)
(2.2 cu. in)
(18.5 sh ton)
19
21
(0.75)
(0.83)
8
(0.31)
6
4
(0.24)
(0.16)
Publicidad
