Operation - Klarfit Vib1000 Manual Del Usuario

OPERATION

1. Insert the vibration trainer into the socket, switch on the red power switch
located on the back of the machine. The display will flash briefly and then
beep to indicate that the machine is in standby mode. The display shows
[---].
2. In standby mode, press the On/Off button on the remote control or
control panel. The unit starts to run. The default setting is Manual Mode
(HL). The operating time starts at 10 minutes, at speed 1.
3. During operation, press the On/Off button on the remote control or the
control panel. The unit switches to standby mode.
4. During operation, press the Program button on the control panel or
press M/P1/P2/P3 on the remote control. The P1/P2/P3 modes are the
Auto modes, M is the Manual mode (HL). When the mode is changed, the
working time is reset to 10 minutes.
5. Press the Time button during operation. Use the [+/-] buttons to set the
time from 1-15 minutes. In Manual mode, the speed can be set from 1-50
minutes by pressing the [+/-] buttons. In AUTO mode, the speed cannot be
adjusted.
Speed table for Auto Modes P1/P2/P3
EN
25