Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance:
-The tension of the pedal clip with the
pedal should be checked weekly,
using a 3mm Allen key to adjust the
set screw.
-Apply a little oil to the contact point of
the pedal clip with the pedal to ensure
that it locks on. -Oil to the pedal
springs regularly. (Pedal instructions
attached)
2. CHECKING THE TIGHTENING
KNOBS.-
The 3 tightening knobs should be
loosened off and sprayed with a
lubricant to ensure that they remain
operative.
MAINTENANCE EVERY 200
HOURS.-
1. CHECKING & ADJUSTING THE
BELT
-Check that the belt is tensioned
properly. If the belt skids it will be
necessary to tighten the belt.
-Remove the side covers (6) and
loosen the nuts a maximum of two
turns Fig.7
-Tighten
the
spanner. Make sure that the nut
rotates the same number of turns on
both sides of the machine (generally 2
turns will be sufficient) otherwise the
drive sprocket might become skewed,
creating a lot more noise and making
it possible for the belt to fall off.
-Tighten up nuts again and put the
side covers (6) back in their place.
-Whenever the tension setting on the
machine is adjusted, readjust the
brakes as well.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
9
small
nuts
with
a
Publicidad
Tabla de contenido
