Fanimation The Ventana FP8032 El Manual Del Propietario página 10

How to Assemble the Blades and Light Kit (continued)
4. Connect the 2-pin connector from the socket
plate to 2-pin connector from motor assembly
(Figure 4).
5. Remove one of the three screws in the housing
light kit assembly. Slightly loosen the remaining
two screws. Assemble the socket plate to the
light plate assembly using the two key slots.
Replace the third screw and securely tighten all
three screws (Figure 5).
6. Insert light bulbs into sockets (Figure 6).
7. Remove finial nut, glass support nut, and rubber
washer from threaded post on socket plate.
Postion glass onto Socket Plate Post and secure
with rubber washer and glass support nut
Assemble finial nut onto threaded shaft.
Do not over-tighten (Figure 7).
SOCKET PLATE
LIGHT SOCKET
FROSTED
GLASS
10
MOTOR ASSEMBLY
2-PIN CONNECTOR
SOCKET PLATE 2-PIN
CONNECTOR
SOCKET PLATE
ASSEMBLY
Figure 4
SCREWS (3)
LIGHT PLATE
ASSEMBLY
Figure 5
50-WATT
MINICAN
Figure 6
LIGHT BULBS (2)
GLASS SUPPORT NUT
RUBBER WASHER
FINIAL NUT
Figure 7