Initial Operation; After Use; Using The Unit - Clatronic PP 3373 Instrucciones De Servicio

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 12
Mount the knob on the glass lid:
To do this, place the knob and the ring collar on a flat
surface.
Place the lid on it upside down.
Push the screw with the silicone seal through the lid from
the inside and screw on the knob so that it is hand-tight.

Initial Operation

Place the device on a heat-resistant surface.
Please ensure that the temperature regulator is turned to 0
(Off) and insert it into the socket of the thermostat. You will
find the socket on the side below a handle.
CAUTION:
If the thermostat is not
inserted correctly, this may
lead to abnormal heating,
of which the consequence
may be damage or acci-
dents. You should therefore
ensure that the thermostat
is inserted correctly.
Connect the device to a properly installed 230 V, 50 Hz
power socket.
Set the temperature control according to what you intend to
do:
Temerature
Adjustment
adjustment
in °C approx.
1
2
over 100°C
3-4
150° - 200 °
5
240° C
NOTE:
The device has reached the correct temperature when the
control lamp on the thermostat goes off. During operation the
control lamp goes on from time to time to show that the correct
temperature is being maintained.

Using the unit

The Party Pan should be preheated for approximately five
minutes. When the control lamp goes off, the pan is ready
for operation.
22
05-PP 3373.indd 22
The cooking time depends on the type and quantity of
food that is to be cooked as well as the degree of cooking.
Please base these times on your own experience.
When turning the food that is being cooked, please use
wooden or Teflon utensils so as not to damage the non-stick
layer.
When cooking is finished the food may be kept warm by
turning the controls to 1.
WARNING:
The Party Pan is hot during use!
Hot steam is emitted from the lid.
To switch the device off, first turn the temperature regulator
to 0 (Off) and remove the plug from the socket.
Do not remove the thermostat from the device until the
device has cooled down, as the temperature sensor is still
very hot after use.
WARNING:
Always pull out the plug from the mains socket before
cleaning and wait until the unit has cooled down.
Do not use any wire brush or other abrasive objects.
CAUTION:
Do not use any acidic or abrasive detergents.
Under no circumstances should the device be immersed
in water for cleaning.
Pan
Please remove any food residues while they are still warm
with a damp cloth or paper towel. In the case of stubborn
residues the pan should be reheated with a little water.
Use
Wash off the pan with a soft sponge and soapy water.
Then wipe with clear water and dry thoroughly with a soft
Keeping warm
cloth. After drying please apply a thin film of edible oil to the
surface.
Fried food,
hamburgers
Lid
Pancakes, scrambled
eggs, ham, bacon
Clean the lid with a soft sponge and a little washing-up liquid.
Roasting
Thermostat
Please clean the thermostat with a soft paper towel or a soft try
cloth.
WARNING:
Never clean the regulator with damp items, as otherwise
this might result in an electric shock or fire.
Never immerse the cable loom in water!

After Use

Cleaning
11.02.2010 17:07:00 Uhr

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pp 3374

Tabla de contenido