Connecting With A Grandioso K1; Notes About The Protection Circuits - Esoteric Grandioso F1 Manual Del Usuario

Connecting with a Grandioso K1

Grandioso K1
Use XLR audio cables to connect the ES-LINK Analog (ESL-A) connec-
tors on this unit with the analog audio output (LINE OUT) connectors
on the Grandioso K1.
o Set the analog output (AOUT) of the Grandioso K1 to ESLA.
12
Analog audio output
(LINE OUT) connectors

Notes about the protection circuits

This unit has a DC protection circuit, an overcurrent protection circuit
and an overheating protection circuit built-in.
When a protection circuit is operating, the power indicator blinks and
one of the following error messages blinks on the display.
DCout ERR!
The DC protection circuit is active.
Turn the unit off once and wait several minutes before turning it
on again.
OverCURNT!
The overcurrent protection circuit is active.
A short might have occurred with the +/− speaker cables. In this
case, turn the unit off and check the speaker cable connections.
Over TEMP!
The overheating protection circuit is active.
The internal temperature has become high. Turn the unit off and
wait a while for the temperature to decrease. You can also change
the installation conditions to improve ventilation.
o If the overheating protection circuit continues to operate for
30 seconds, the unit will automatically turn itself off. After this,
the POWER button will be disabled for as long as the internal
temperature remains high.
If the indicator continues to blink even after likely causes have been
eliminated, contact the store where you purchased the unit.