Options And Functions; Loading The Racks - Franke FDW 614 D7P DOS D Manual De Usuario

OPTIONS AND FUNCTIONS

OPTIONS can be selected directly by pressing the corresponding button (see CONTROL PANEL). If an option is not compatible with the selected
program (see PROGRAMS TABLE), the corresponding LED flashes rapidly 3 times and beeps will sound. The option will not be enabled.
MULTIZONE
If there are not many dishes to be washed, a half loading may be used
in order to save water, electricity and detergent.
Select the program and then press the MULTIZONE button: the symbol
of the chosen rack will appear on the display. By default the appliance
washes dishes in all racks.
To wash only the specific rack, press this button repeatedly:
shown on the display (only lower rack)
shown on the display (only upper rack)
shown on the display (only cutlery rack)
shown on the display (option is OFF and the appliance will wash
dishes in all racks).
Remember to load the upper or lower rack only, and to reduce the
amount of detergent accordingly. If upper rack is removed, please
apply detergent directly to tub instead of detergent dispenser.
.....................................................................................................................................................................................
DELAY
The start time of the program may be delayed for a period of time
between 1 and 12 hours.
1. Press the DELAY button: the corresponding «h» symbol appears on the
display; each time you press the button, the time (1h, 2h, etc. up to
max. 12h) from the start of the selected wash cycle will be increased.
2. Select the wash program, press the START/PAUSE button and within
4 seconds close the door: the timer will begin counting down.
3. Once this time has elapsed, the indicator light «h» switches off and
the wash cycle begins.
To adjust the delay time and select a shorter period of time, press the
DELAY button. To cancel it, press the button repeatedly until the selected
delayed start indicator light «h» switches off.
The DELAY function cannot be set once a wash cycle has been
started.
.....................................................................................................................................................................................
TABLET (Tab)
This setting allows you to optimize the performance of the program
according to the type of detergent used.
Press the START/PAUSE button for 3 seconds (the corresponding sym-
bol will light up) if you use combined detergents in tablet form (rinse
aid, salt and detergent in 1 dose).
If you use powder or liquid detergent, this option should be off.

LOADING THE RACKS

CUTLERY RACK
The third rack was designed to
house the cutlery.
Arrange the cutlery as shown in the
figure.
A separate arrangement of the
cutlery makes collection easier after
washing and improves washing and
drying performance.
OPERATION INDICATOR
A LED light projected on the floor indicates that the dishwasher is
working. One of the following operating modes can be selected:
a) Disabled function.
b) When the cycle starts the light goes on for few seconds, stays off during
the cycle and flashes at the end of the cycle.
c) The light stays on during the cycle and flashes at the end of the cycle
(default mode).
If the delayed start was set, the light goes on either for the first few
seconds or the entire duration of the countdown, based on whether
mode b) or c) was set.
The light goes off every time the door is opened. To select the mode
you prefer, switch on the machine, hold down button P until one of the
three letters appears on the display, press button P until you reach the
desired letter (or mode), hold down button P to confirm the selection.
Note: If CoolDry is active and it opens the door, then Operation
Indicator will not flash at the end of cycle.
.....................................................................................................................................................................................
CoolDry
CoolDry is a convection drying system which automatically opens the
door during/after drying phase to ensure exceptional drying perfor-
mance every day. Door opens at the temperature that is safe to your
kitchen furniture.
As additional steam protection, special designed protection foil is added
together with the dishwasher. To see how to mount protection foil
please refer to (INSTALLATION GUIDE).
CoolDry functionality could be disabled by the user as follows:
1. Go to the Dishwasher software menu pressing and holding P button
(6 sec).
2. You are currently in Light Control Menu (please refer to OPERATION
INDICATOR description), if you don't want to change anything
please press and hold P button (until one of the two letters appears
on the display).
3. You switched to CoolDry Control Menu, you could change status of
CoolDry functionality by pressing P button:
E d
– enabled – disabled
To confirm the change and exit from the Control Menu please press and
hold P button (3 sec).
Knives and other utensils with sharp edges must be positioned
with the blades facing downwards.
The geometry of the rack makes it
possible to place such small items
as coffee cups in the area in the
middle.
EN
7