Blade Attachment - Hinkley 60"SWELL Manual De Instrucciones

BLADE ATTACHMENT

Downrod
Yoke Cover
Blades Ring
Yoke Cover
Downrod
Blades Ring
10
| hinkley.com
Canopy
Trim Ring
Fig.1
Fig.2
NOTE:
Remove any rubber supports that are installed for
shipping.
Fasten blade to motor with provided screws, lock washers and at
washers. Repeat procedure for remaining blades. Make sure screws are
TIGHT! Loose motor screws can contribute to unnecessary hum during
operation.
NOTE:
Cordless power screwdrivers are NOT recommended,
as they usually strip the heads of the screws and
usually will not fully compress the lock washers on
the motor screws. Use a large at blade screwdriver
for nal tightening to fully compress the washers. This
will help ensure proper alignment of the blades and
noise-free, wobble-free running.
Locate 9 blade attachment screws. Slide one
1
blade onto the motor as shown in Fig.2,
aligning holes in blade with holes on the
edge of the motor.
First install a short screw to the hole in the middle
2
of the blade, repeat for all three blades.
Place blade ring on the blade, aligning all holes
3
in blade with all holes on blade ring, install 2 blade
attachment screws.
Make sure to completely tighten completely
4
Tighten all screws securely.
each screw .