Blade Attachment - Hinkley TROPIC AIR 52 Manual Del Propietário

BLADE ATTACHMENT

NOTE:
One fan per power circuit.
WARNING: The fan motor assembly is shipped with rubber packing
mounts to prevent movement during transportation. Remove the
five rubber packing mounts from the fan motor assembly and
discard prior to attaching the blade arms.
Place rubber washer on screw. Insert this assembly through
1
the blade and start the screw into the blade arm. Repeat
this procedure without tightening the screw until all 3
screws have been started into the blade arm (Fig. 1).
Tighten each screw starting with center screw.
2
Fasten blade assembly to motor with provided screws and
3
lock lockwashers. Repeat procedure for remaining blades
(Fig. 2). Make sure screws are TIGHT! Loose motor screws
can contribute to unnecessary hum during operation.
Cordless power screwdrivers are NOT recommended, as
they usually strip the heads of the screws and usually will not
fully compress the lock washers on the motor screws. Use a
large flat blade screwdriver for final tightening to fully
compress the washers. This will help ensure proper
alignment of the blades and noise-free, wobble-free running.
10 | hinkley.com
NOTE:
Screw
Rubber Washer
Blade Arm
Fig. 1
Screws
Fig. 2
Blade
Blades
Assembly