Troubleshooting - BLACK&DECKER FSM1610 Manual De Instrucciones

Troubleshooting

If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local Black & Decker repair agent.
Problem Step Possible solutions
Check the unit is plugged in at the wall
The steam mop is 1
socket.
not turning on.
Check the unit is switched on using the on/
2
off switch (1).
3
Check the fuse in the plug.
The steam mop will only produce steam
The steam mop is 4
once the handle is pulled back from the
not producing
upright position.
steam.
Check that the water tank (3) is full and
5
correctly fitted.
NOTE: When first filled or after running dry it
can take up to 45 seconds for steam to be
produced.
Check that the Steam head (5) is firmly
6
docked into the steam mop body (12).
7 Check steps 1, then 2 then 3.
The steam mop 8 Check steps 4, then 5, then 6 and then 3.
stops producing
steam during use.
The steam mop has 3 settings. Turn the
The steam mop is 9
autoselect dial (2) to increase the amount of
producing too
steam being produced.
much steam during
use.
The steam mop is
10 Check step 5.
producing too little
The steam mop has 3 settings. Turn the
11
steam during use.
autoselect dial (2) to reduce the amount of
steam being produced.
Refer to the assembly chapter of the manual
Steam is escaping 12
for correct fitting instructions of all parts and
from unexpected
accessories.
areas of the unit.
Where can I get 13 www.blackanddecker.co.uk/steammop
further information
www.blackanddecker.ie/steammop
/ accessories for
my steam mop.
(Original instructions) ENGLISH
7