Light Kit Assembly - Craftmade Mobi MOB60 Guia De Instalacion

9. Light Kit Assembly .

Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws.
Align slotted holes in fitter plate with loosened
screws in motor plate, allowing molex
connectors to come through center hole in
fitter plate. Twist fitter plate to lock. Re-insert
screw that was previously removed and
securely tighten all 3 screws with a Phillips
screwdriver.
Connect WHITE wire from motor housing to
WHITE wire from the LED light kit and BLUE
(or BLACK) wire from motor housing to
BLACK wire from LED light kit. Make sure
molex connections snap together completely.
Remove 3 screws from under fitter plate.
Carefully arrange wiring within the back of
LED light kit. Align holes in LED light kit
with holes in fitter plate. Re-insert screws
that were previously removed and securely
tighten all 3 screws with a Phillips
screwdriver.
Locate slots on glass shade and align with
nodules on inside of fitter plate.
up on glass shade and turn
(clockwise) until it slides completely into place.
Gently push
to the RIGHT
motor housing
motor plate
molex connections
motor housing
LED light kit
motor housing
nodules
slots
page 8
fitter plate
screw
fitter plate
molex connections
glass shade