Troubleshooting - LED Lights
Problem (Lights)
Possible Cause
LED lights do NOT
LED wires disconnected.
illuminate when light
switch is pressed ON,
but LED light switch
illuminates.
Faulty LED light(s).
LED lights do NOT
Battery not installed
illuminate when light
properly.
switch is pressed ON,
AND LED light switch
Dead 9V battery.
does NOT illuminate.
Battery box lead wires
disconnected.
Transformer lead wires
disconnected (if used).
Switch wire harness
disconnected.
LED lights DO
Bad LED light switch.
illuminate when light
switch is pressed ON,
but LED light switch
does NOT illuminate.
Check Procedure
Check to ensure that wires at
each LED spade terminal are
firmly connected and not loose
behind control panel.
If good connection at LED, and
other LED lights are
operational, then bad LED.
Check battery orientation.
Has battery been used
previously?
Check that battery box lead
wire connector is engaged and
locked with no loose wires at
the connectors.
Check that transformer output
connector is engaged and
locked with no loose wires at
the connectors.
Check that the switch wire
harness is connected properly
to back of switch.
Switch wire harness is
attached and LED lights
illuminate.
24
Prevention/Solution
Reconnect wires at spade connectors on the LED.
If wires will not stay attached and are loose,
contact Saber for warranty replacement parts.
Contact Saber for a warranty replacement part.
Install battery (make sure that "+" and "-"
connectors are oriented correctly).
Replace battery with new alkaline battery.
Reconnect the battery lead wire connectors and
ensure the connector tab lock is closed. If wires
pull loose from the connectors, contact Saber for
warranty replacement parts.
Reconnect the battery lead wire connectors and
ensure the connector tab lock is closed. If wires
pull loose from the connectors, contact Saber for
warranty replacement parts.
Reconnect switch wire harness to switch ensuring
that harness locks to switch.
Contact Saber for a warranty replacement part.