Use And Care - Saber K00SB5317 Guía De Montaje

USE AND CARE

DANGER
Do not insert any tool or foreign object into the valve
outlet. You may damage the valve and cause a leak.
Leaking gas may result in explosion, fire, severe personal
injury, or death.
WARNING
Outdoor gas appliance is not intended to be installed in
Ÿ
or on a boat.
Outdoor gas appliance is not intended to be installed in
Ÿ
or on an RV.
Never attempt to attach this side burner to the self-
Ÿ
contained gas system of a camper trailer or motor
home.
Do not use side burner until leak-tested.
Ÿ
If a leak is detected at any time, STOP and call the fire
Ÿ
department.
If you cannot stop a gas leak, immediately close gas
Ÿ
valve and call gas supplier or your fire department!
CAUTION
Putting out grease fires by closing the lid is not
Ÿ
possible. Side burners are well ventilated for safety
reasons.
Do not use water on a grease fire. Personal injury
Ÿ
may result. If a grease fire develops, turn knobs and
gas valve off.
Do not leave side burner unattended while reheating
Ÿ
or burning off food residue on HI. If side burner has
not been regularly cleaned, a grease fire can occur
that may damage the product.
Side Burner Ignitor Lighting
Do not lean over side burner while lighting.
1. Turn OFF all control knobs.
2. Turn ON gas at source.
3. Open side burner lid during lighting.
4. To ignite push in and turn side burner control knob to
5. Push and hold ELECTRONIC IGNITION button until the burner
lights.
6. If ignition does NOT occur in 5 seconds, turn the control knobs
OFF, wait 5 minutes, and repeat the lighting procedure.
7. Repeat steps 4 through 6 for second burner.
CAUTION
If ignition does NOT occur in 5 seconds, turn the
control knobs OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
WARNING
Turn controls and gas source OFF when not in use.
Side Burner Match-Lighting
Do not lean over side burner while lighting.
1. Turn OFF all control knobs.
2. Turn ON gas at dource.
3. Open lid during lighting.
4. Place lit match near burner.
5. Push in and turn control knob of the burner you are lighting
to the position. Ensure burner stays lit.
6. Light adjacent burner by pushing
knob in and turning to the
4
.
position.