Craftsman 196.205080 Manual De Usuario página 25

to the same length as the one you have
just removed.
6. Feed the new Wire Liner into all the way
into the Gun Cable.
Note: It is very important to keep the Gun
Cable as straight as possible to avoid inter-
nal damaging to the Gun Cable when insert-
ing the new Wire Liner.
7. Replace the brass fitting at the end of the
Gun Connector and tighten with a 12 mil-
limeter wrench.
8. Insert the Gun Connector into the port of
the front of the welder and hand tighten
the threaded end.
Figure 22. Replacing a Wire Liner
PREVENTIVE MAINTENANCE
Except for internal and external cleaning,
cleaning the nozzle, and occasionally
retightening screws, there is no periodic
maintenance recommended for your welder.
TROUBLESHOOTING
The following TROUBLESHOOTING
table is provided as a guide to help resolve
some of the more common problems that
could be encountered. This table does not
provide all possible solutions, only those
possibilities considered to likely be common
faults. The table consists of a TROUBLE or
symptom, a POSSIBLE CAUSE for the
symptom, and a POSSIBLE REMEDY for
that symptom.
25