Leveling The Range - Avanti ER2001G Manual De Instrucciones

3-Wire Power Cord Installation
•
Remove the Terminal Block Access Plate on the back
of range by removing the 2 fixing screws.
•
Assemble the strain relief in the hole on bracket.
•
Insert the power cord through the strain relief and
tighten.
•
Allow enough slack to easily attach the cord terminals
to the terminal block.
•
Remove the 3 wire terminal nuts and washers from
the terminal block.
•
Plug the terminal holes of power cord. The neutral or
ground wire of the power cord must be connected to
the neutral terminal located in the center of terminal
block. The power leads must be connected to the
outside terminals.
•
Plug washers and tighten nuts securely.
•
Assemble the Terminal Block Access Plate.
4-Wire Power Cord Installation
•
Remove the Terminal Block Access Plate on the back
of range by removing the 2 fixing screws.
•
Assemble the strain relief in the hole on bracket.
•
Insert the power cord through the strain relief and
tighten.
•
Allow enough slack to easily attach the cord terminals
to the terminal block.
•
Remove the 3 wire terminal nuts and washers from
the terminal block.
•
Remove the ground strap from the frame of range and
terminal by removing its screw and cutting is as
shown.
•
Plug the terminal holes of power cord. The neutral wire of the power cord must be connected to
the neutral terminal located in the center of terminal block. The ground wire of the power supply
cord must be attached to the frame of range by using the green colored grounding screw. The
power leads must be connected to the outside terminals.
•
Plug washers and tighten nuts securely.
•
Assemble the Terminal Block Access Plate.
¬

LEVELING THE RANGE

U
The range must be level to obtain proper operating. The four screws
type leveling legs located on the corners at the bottom of range should
be adjusted by turning them clockwise to make the range higher or
counter-clockwise to lower the range until the range is level. Use a
level on surface units to check the leveling of the range.
Terminal Block
Access Plate
Cut Ground Strap
Terminal Block
Neutral Wire
Power Wires
Power Cord
Bracket
Cut Ground Strap
Terminal Block
Neutral Wire
Grounding Wire
Power Wires
Power Cord
17
Screws
Grounding Screw
Bracket