Premier MCO-4992 Manual De Instrucciones página 24

4. Extraction the thread length about 10CM.
Attention: Make sure the clockwise direction of the thread
end in putting the bobbin, shown in the right Fig:
5. Pull out 10cm thread end from the bobbin thread bobbin, shown in Fig5.
6. Put the pulled bobbin thread and upper thread to the left by left hand, shown in Fig 6.
7. Rotate counterclockwise the hand wheel (24) to make the needle move up and down after the bobbin
thread and upper thread put to the left, shown in Fig7.
8. Hold upper thread by left hand during rotating the hand wheel (24) to make the needle move up and
down, pull on the upper thread to bring the lower thread up, pull both thread to the back under the
presser foot ,pull out 10cm shown in Fig8.
9. Put on the transparent cover (18) after the bobbin thread and upper thread pressed under the presser
foot (17), shown in Fig 9.
1. Please in strict accordance with the following steps in sewing.
2. Function adjustment wheel (2) is not allowed to rotate when the machine is running.
4. Adjustment of function adjustment wheel (2) requires rotating counterclockwise the hand
wheel (24) to lift the sewing needle (16) to the highest position.
Texture-relative attentions:
1. The machine can't provide ordinary sewing to elastic textures, such as towel cloth, lint, elastic
knitted fabric, etc.
2. Texture thickness recommended: 0.3mm-1.8mm.
Ordinary sewing
Introduction to applicable functions
P-7