Timer Function; Water Bucket - Danby DDR050BGWDB Manual Del Propietário

OPERATING INSTRUCTIONS

TIMER FUNCTION

Auto On Function
1. Press the timer button until the auto on indicator
light illuminates.
2. Use the up and down arrows to select the
desired amount of time before the appliance
should turn on. The up and down arrows
will add or subtract 30 minutes of time up to
10 hours, then at 1 hour increments up to a
maximum of 24 hours.
3. The time selected will appear on the display
panel and will count down until the appliance
turns on.
Auto Off Function
1. Press the timer button until the auto off indicator
light illuminates.
2. Use the up and down arrows to select the
desired amount of time before the appliance
should turn on. The up and down arrows
will add or subtract 30 minutes of time up to
10 hours, then at 1 hour increments up to a
maximum of 24 hours.
3. The time selected will appear on the display
panel and will count down until the appliance
turns off.
Using Auto On and Auto Off Simultaneously
The auto on and auto off functions can be used at
the same time by fi rst setting one and then the other.
Both indicator lights will illuminate and the display
will count down to the appliance either turning off
or on, whichever function was set fi rst.
Note: The timer will not cycle the appliance on and
off indefi nitely. The auto on and auto off timers will
function one time and then the appliance will return
to regular functioning.
Turning the appliance off, pressing the default
button on the remote or unplugging the appliance
will clear all memory settings, including the timer.
WATER REMOVAL
There are two ways to remove collected water from
the appliance.

1. Water Bucket

The dehumidifi er will automatically collect
condensed water in the water bucket. When the
bucket is full, the compressor and fan will turn off
and the full bucket indicator light will turn on. The
display will show "P2".
To empty the bucket, gently remove it from the
appliance by gripping both sides and pulling
outward. Be cautious when removing the bucket, it
will be full and can be heavy.
Do not place the water bucket directly on the fl oor.
The bottom of the bucket is uneven and it will fall
over and spill water.
Empty the bucket and replace it in the appliance.
The dehumidifi er will not function without the bucket
installed.
2. Continuous Drain
Water can be removed from the appliance using the
continuous drain and a standard garden hose (not
provided).
Before using any automatic drain functions,
check that all drain ports are clean and free of
debris. There is one drain port inside the bucket
compartment of the appliance, remove the bucket
to see it. There is one drain port on the back of the
appliance where the drain hose attaches. All drain
ports should be cleaned with a pipe cleaner prior to
use.
Remove the cover from the continuous drain outlet
and attach the female threaded end of the garden
hose to the back of the appliance. Direct the other
end of the garden hose to a bucket or fl oor drain.
Ensure that the garden hose is not bent and goes
straight down from the back of the appliance. The
continuous drain is only activated by gravity so any
bends or upward motion in the hose will stop the
water from draining.
The garden hose should be cut so that it is no more
than 1.8 m (6 feet) long. If the drain hose is too
long water may not drain completely which can
lead to stagnant water and mildew build up inside
the hose.
5