Tabla de contenido
Publicidad
Componentes
1
2
3
2x
4.25" (108 mm)
3.75" (95 mm)
3.25" (83 mm)
1x
2.75" (70 mm)
X
2.25" (57 mm)
1.75" (44 mm)
1.25" (32 mm)
0.75" (19 mm)
0.25" (6 mm)
2.126
2.126
12.992
4
5.118
3.900
Herramientas necesarias
888-24-227-G-00 rev. B • 07/13
A
1x
1x
3x
WORKSURFACE TEMPLATE FOR WORKFIT-B, HD
Align REAR Edge of Worksurface X distance
Lay this template on the bottom of your worksurface
from the back of the Base Brackets.
See table for value of X based on the depth of
to drill the holes to attach the WorkFit-D, Base.
your worksurface.
Back of Base Bracket
35.197
Depth of
Depth of
X
X
Worksurface
Worksurface
23.50 - 24.25"----0.25"
597 - 616 mm ---6 mm
24.25 - 25.00"----0.75"
616 - 635 mm ---19 mm
25.00 - 25.75"----1.25"
635 - 654 mm ---32 mm
25.75 - 26.50"----1.75"
654 - 673 mm ---44 mm
26.50 - 27.25"----2.25"
673 - 692 mm ---57 mm
27.25 - 28.00"----2.75"
692 - 711 mm ---70 mm
28.00 - 28.75"----3.25"
711 - 730 mm ---83 mm
28.75 - 29.50"----3.75"
730 - 749 mm ---95 mm
29.50 - 30.25"----4.25"
749 - 768 mm ---108 mm
Use Drill Bit #21,
Center Point of Base Brackets
Ø 0.19" (4.8 mm)
to drill these 8 holes
0.375" (9.5 mm) deep.
TIPPING HAZARD!
Center Worksurface from Side-to-Side Across Base Brackets.
Failure to follow these instructions may make this product unstable
Brake Release
and may result in equipment damage and/or personal injury.
DIMENSIONS ARE IN INCHES
14mm
B
1x
2x
16x
M5 x 6mm
3x
M2.9 x 8mm
4.25" (108 mm)
3.75" (95 mm)
3.25" (83 mm)
2.75" (70 mm)
2.25" (57 mm)
1.75" (44 mm)
1.25" (32 mm)
0.75" (19 mm)
0.25" (6 mm)
Use Drill Bit #46,
Ø 0.081" (2mm)
to drill these 3 holes
0.24" (6 mm) deep.
Use Drill Bit #21,
Ø 0.19" (4.8 mm)
to drill these 9 holes
0.375" (9.5 mm) deep.
823-558-00 rev.A 05/13
1/4"
#21, Ø 0.19" (4.8mm)
#46, Ø 0.081" (2mm)
C
17x
#12-14 x 5/8"
4x
ST3.9 x 16mm
1x
2.5 mm
5 of 18
Publicidad
Tabla de contenido
