Translation of the original instructions
Acid projection hazard!
• Wear safety goggles and protective gloves
• If your eyes or skin come into contact with battery acid, rinse the
Connection / disconnection
• Disconnect the power supply before connecting/disconnecting
• The terminal of the battery that is not connected to the car frame
• After the charging process, disconnect the battery charger from
Connection:
• Class II device (charger booster)
• Class III device (booster)
• This machine is fuse-protected
• Connection to the mains must be made according to the natio-
Maintenance:
• If the charging / power supply cable is damaged, the product
• The power supply cable cannot be replaced. If the cable is
• Service should be performed by a qualified person
• Warning! Always remove the power plug from the wall socket
• Regularly take off the cover and remove dust with an air gun. Take
• Under no circumstances should solvents or other aggressive
• Clean the device's surfaces with a soft, dry cloth.
Regulations:
• The device complies with European Directive.
• The certificate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
• Equipment in conformity with Moroccan standards.
• The declaration C( مCMIM) of conformity is available on our
10
GYSPACK 660 / 750
affected part of the body with plenty of water and seek immediate
medical assistance.
the device to/from the battery
must be connected first. The other connection must be made on
the car frame, far from the battery and the fuel line. The battery
charger must be connected to the power supply network.
the power supply network and remove the connector from the
car frame and then the connector from the battery, in this order.
nal installation regulations.
must be disposed.
damaged,the device should not be used.
before carrying out any work on the device.
the opportunity to have a qualified person check the electrical
connections with an insulated tool.
cleaning agents be used.
website (see cover page).
EN