Hardware Installation; Technical Specifications - Velleman CAMCOLBUL27 Manual Del Usuario

• with B/W night vision (IR LEDs)
• super high resolution
5.
Overview
Refer to the illustrations on page 2 of this manual.
1 lens
2 IR LEDs
3 light sensor
4 sunshield
6.

Hardware installation

Refer to the illustrations on page 2 of this manual.
• Choose a location for the camera, keeping following guidelines in mind:
o
do not install the camera in locations where extremely high or low
temperatures or excessive vibrations may occur.
o
avoid mounting the camera near high electro-magnetic fields.
o
do not aim the camera at the sun or other extremely bright objects or
reflections (e.g. metal doors).
• Use the mounting bracket [6] to determine the location of the mounting
holes. Drill the holes and secure the bracket [6] using 3 screws.
• Attach the camera to the mounting bracket [6] with the camera bolt [7].
• Connect the power connector [B] to the 12VDC power supply (not incl.).
• Connect the BNC connector [A] to a monitor (not incl.)
• Point the camera towards the field of interest and tighten the position bolt
[5].
7.

Technical specifications

pick-up element
pixels
horizontal resolution
min. illumination
IR LEDs
range (IR light)
S/N ratio
water-resistance
electronic shutter
lens angle
Colour Rolling Suppress
white balance
AGC
standard board lens
video output
16.12.2010
CAMCOLBUL27
5 position bolt
6 bracket
7 camera bolt
1/3" HR colour CCD image sensor -SONY Effio
DSP
753(H)x582(V) PAL
600 TV lines
0.1 Lux (F2.0) ; 0 Lux (IR on)
21
15m
> 48dB (AGC off)
IP67
1/50 to 1/100000s
92.6°
yes
automatic
yes
f3.6mm / F2.0
1Vpp @ 75 ohms
4
©Velleman nv