Features - Surtek EA607 Manual De Usuario Y Garantía

form. Holding the workpiece in your hand or
against your body is unstable, and may lead to
loss of control.
• Keep your hands away of the motion parts.
• Always use goggles and dust mask when you
are grinding, specially when grind over your
head.
• Be careful with the sparks detached of the
disc when work. Hold the grinder such way
that the sparks fly away of you, other persons
or flammable materials.
• Don't touch the work piece immediately af-
ter of the operation, could be very hot and can
cause hurts.
THE KICKBACK
The kickback is a sudden reaction. The punc-
tured or hooked produces a quick decrease
speed rate causing loose control of the tool
which is directed towards the side which is the
operator.
The kickback is the result of an inappropri-
ate tool use or an incorrect operation. Can be
avoided following these instructions:
1. Keep a firm grip with both hands on the
tool. Position your body properly to resist the
force of kickback. The operator can control
torque reactions if the correct warnings are
taken.
2. Never place your hand close to the rotating
accessory. It can cause a kickback over your
hand.
3. Never place your body on the kickback area;
the kickback will propel the tool to the oppo-
site direction of the rotation abrasive disc.
4. Use extra care when working with edges.
These tend to engage the disc.
5. Don't use the tool with cutting saws. These
produce kickback.

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. POWER ON SWITCH.
2. ROTATION SWITCH FOR REAR GRIP.
3. SIDE HANDLE.
4. GUARD OF DISC.
5. LOCK-ON SPINDLE BUTTON.
6. SAFETY SWITCH & LOCK-ON BUTTON FOR
CONTINOUS OPERATION.
E N G L I S H •
5
ASSEMBLY INSTRUCTIONS
WARNING: Remove the grinder from the
carton and examine it carefully. Do not discard
the carton or any packaging material until all
parts are examined.
LATERAL HANDLE
The lateral handle
must be used always
that the machine is
running. Screw the
lateral handle inside
the holes, could be on
the right, left or superior side. Your choice is
determined by your convenience and ability to
keep the complete control.
GUARD
NOTE: Before operation, make sure that the
guard it's fixed in place.
The blade guard is a
safety device that pre-
vents injuries caused
by debris of abrasive
discs.
When installing the guard, make sure the
guide of the guard is aligned with the notch
on the cover of the gearbox.
Rotate the guard to the left until it locks in the
correct position. Screw to fix it in place.
INSTALL AND REMOVE THE ABRASIVE DISC
To Install:
1. Disconnect the plug from the electrical out-
let. Make sure that the guard is securely in
place.
2. Remove the outer
flange.
3. Check that the inner
flange is properly seated
on the spindle. It will click
into place on the spindle,
and will cause the spindle
U se r ' s m an ua l
1
6
2
3
4
11