Genesis GBS321A Manual Del Operario página 10

APPLICATIONS
Your belt sander is an excellent multi-purpose sanding tool, that when used properly can save you hours of arm
wearying work and produce a fine finish for your project. As with any new tool, before using it on a project, first
practice on scrap material to become comfortable with the weight and balance of the sander. You may also want
to experiment with various grit sanding belts to get a better idea of how quickly they remove material and quality
of finish they produce.
The most common mistake made when using a belt sander is pressing down on the sander during sanding
operation. Your belt sander is designed with the proper weight to apply to the sanding belt. Pressing down on the
sander will result in:
– Clogging the sanding belt
– Wearing out the belt prematurely
– undue strain on the motor with possible motor failure
– Slow sanding belt speed
– Irregular belt tracking
– Creating an uneven work surface
– Drive belt breakage
Allow the weight of the tool to provide the downward pressure needed for efficient sanding, while using both
hands to guide the tool.
WARNING:
during tool operation.
WARNING:
stopping the tool. Otherwise a poor surface finish or sanding belt damage may occur.
WARNING:
Not doing so may cause the operator to lose control of the tool and may lead to serious
personal injury.
WARNING:
work may be thrown towards the operator causing serious injury.
Steps to Operate the Belt Sander:
1. Secure the workpiece with clamps or other means to prevent it from moving under the sander.
2. Make sure the power cord is clear of sander.
3. firmly grasp both the front and rear handles then turn on the sander. Allow the motor to reach full speed and
engage the trigger "Lock-oN", if desired.
4. While keeping the sander level with the workpiece, begin a forward sanding stroke as you lower the sander to
the work surface.
5. Move the sander back and forth with overlapping strokes over a fairly wide area to obtain an even surface.
6. use the hand on the rear handle to control the sander and the hand on the front handle to guide the sander.
7. Avoid rocking or tilting the sander. This can cause deep cuts and gouges in the work surface.
8. Keep the sander in motion. Pausing in one spot will allow the belt to eat into the work, making the surface
uneven.
9. When ready to stop sanding, lift the sander from the work surface before turning it off. Disengage the "Lock-oN"
feature, release the trigger and allow the sander to come to a complete stop before setting it down.
ACCESSORIES
This belt sander only works with a 3" x 21" sanding belt.
3"x21" Variable Speed Belt Sander
Operator's Manual
Always wear safety glasses with side shields or a full face shield
The sander should not be touching the workpiece when starting or
Always maintain a firm grip on the tool with both hands at all times.
Always secure the workpiece. Unsecured or inadequately secured
GBS321A