Allmand PORT-A-LITE PAL 2000W4 Manual Del Operario página 8

WARNING
Shock Hazard.
Positioning a portable work light on a wet surface or in water
will result in death or serious injury. Always position the work
light on a dry surface away from areas where water may flow
or accumulate.
Do not set up the work light in an area where winds exceed 10
mph (16 km/h).
WARNING
Unsafe Operation Hazard.
Operating the portable work light with the mast fully elevated
in winds exceeding 10 mph (16 km/h) can cause work light
tip over resulting in death or serious injury. Always fully lower
the mast when winds are expected to exceed 10 mph (16
km/h).
Work Surface
The portable work light must be placed on a firm, stable surface
capable of supporting the total weight of the work light. The
surface should be level, and must not exceed a grade of 5%
(2.8° incline) in any direction. Be sure to chock the front casters
and rear wheels before using the work light.
WARNING
Rollover / Tipover Hazard.
Positioning the portable work light on soft or unstable ground
could cause work light rollover resulting in death or serious
injury. Always position the work light on a firm, level and stable
surface.
Operating The Port-A-Lite
To Operate The Port-A-Lite
1. Install and connect the lamp fixtures.
8
1. Remove the handle nuts and flat washers from the studs
on the base assembly, and remove the lamp fixtures
from the studs. Remove the plastic washers from the
studs on the base and install onto the studs on the light
bar. Place the center hole of each lamp fixture yoke
onto the stud on the light bar, and secure with the flat
washer and handle nut.
Note: Do not attempt to use the lamp fixtures while fastened to
the base assembly, or as a hand held light source.
WARNING
Burn Hazard.
Handling light fixtures when they are hot could result in death
or serious injury. Always keep clear of light fixtures when
illuminated or hot.
2. Loosen the hook and loop cable ties securing the cords.
Route the lamp cables up through the metal loop behind
the winch, then connect the lamp cables to the lamps.
2. Position the lamp fixtures. The lamp fixtures may be
rotated left / right, and up / down.
3. Raise the mast to the desired height.
1. Crank the mast winch handle clockwise to raise the
inner mast to the preferred height.
4. Connect the power cords and turn on the work lights.