Mounting The Device - HQ-Power VDPL192UV Manual Del Usuario

• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.

4. Mounting the Device

• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
5. Description
1. on/off switch
2. power socket
3. DMX output
4. DMX input
5. sound sensitivity knob
6. DIP switches
7. power LED
8. DMX LED
6. Use
Function
DMX
Slave
Sound control
M
A
Auto
S
T
Strobe
E
R
All on
The first device after the controller will be the master device. Set the mode according to the table above.
VDPL192UV
DIP
1 2 3
X X X
Auto speed
X X X
X X X
X = not used,
4
4 5 6 7
DMX address
X X X X
X Strobe speed
X X X X
= on, = off
8 9 10
X X
HQPOWER