The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or
gangs is prohibited because of the danger of fire that is involved with this.
Make sure that the power cable is undamaged and has not been installed under or over
hot or sharp surfaces.
This unit is not designed to be installed in an RV or used with an inverter.
The electrical outlet must be protected by a 16A safety cut-out switch.
The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.
13 Design and Function
This chapter provides you with important safety notices on the design and function of the
device.
14 Operation and Handing
This chapter provides you with important notices with regard to operating the device.
13.1 Complete overview
(1) Upper hinge
(2) Upper control panel
(3) Shelves (5 pcs)
(4) Lower control panel
(5) Air inlet
(6) Door frame (lockable)
(7) Air outlet
33