Riello RS 64 MZ Instrucciones De Instalación, Funcionamiento Y Mantenimiento página 19

OPENING THE BURNER
(A)
TO OPEN THE BURNER (A):
- switch off the electrical power.
- Remove screw 1) and withdraw cover 2).
- Disengage the articulated coupling 3) from
the graduated sector 4).
- Remove screw 5), the split pin 9) and pull the
burner back by about 100 mm on the slide
bars 6). Disconnect the probe and electrode
leads and then pull the burner fully back.
- Turn the burner as shown in the figure and fit
the split pin 9) into one of the slide bar holes
so that the burner remains in position.
Now extract the gas distributor 7) after having
removed the screw 8).
TO CLOSE THE BURNER (A):
- remove the split pin 9) push the burner until it
is about 100 mm from the sleeve.
- Re-connect the leads and slide in the burner
until it comes to a stop.
- Refit screw 5), the split pin 9) and pull the
probe and electrode leads gently out until
they are slightly stretched.
- Re-couple the articulated coupling 3) to the
graduated sector 4).
D535
15