Industry Canada Statement - Danby Parcel Guard DPG37U Manual Del Propietário

Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
SAFETY REQUIREMENTS
• Ensure that servicing is done by factory
authorized service personnel to minimize
product damage or safety issues.
• Consult the repair manual or owner's guide
before attempting to service this product. All
safety precautions must be followed.
• Follow handling instructions carefully.
DANGER: The power cord can be a potential
tripping hazard. The power cord should be located
in a area that does not cross walking paths or
traffi cked areas.
CAUTION: Children should be supervised to ensure
that they do not play with the Parcel Guard.
DANGER: Risk of child entrapment. Before throwing
away an old Parcel Guard, ensure that the lower
door is removed or secured closed so that no small
child may climb inside.

INDUSTRY CANADA STATEMENT

This device complies with Industry Canada license-
exempt RSS standard.
1. Operation is subject to the following two
conditions: This device may not cause
interference.
2. This device must accept any interference,
including interference that may cause undesired
operation of the device.
IC RADIATION EXPOSURE STATEMENT
This equipment complies with IC RSS-102 radiation
exposure limit set forth for an uncontrolled
environment. This equipment should be installed and
operated with minimum distance 20cm between the
radiator and your body.
FCC INTERFERENCE STATEMENT
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation.
This equipment generates uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
• Connect the equipment into an outlet on a
• Consult the dealer or an experienced radio/TV
FCC Caution: To assure continued compliance, any
changes or modifi cations not expressly approved
by the party responsible for compliance could
void the user's authority to operate this equipment.
(Example - use only shielded interface cables when
connecting to computer or peripheral devices).
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC RF radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed
and operated with a minimum distance of 20
centimeters between the radiator and your body.
This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
The antennas used for this transmitter must be
installed to provide a separation distance of at least
20 cm from all persons and must not be co-located
or operating in conjunction with any other antenna
or transmitter.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference
SAVE THESE INSTRUCTIONS!
2
and receiver.
circuit different from that to which the receiver is
connected.
technician for help.
received, including interference that may cause
undesired operation.