Publicidad
Idiomas disponibles
Idiomas disponibles
MIXING M0TOR SPECIFICATIONS
Before starting the machine check the
correspondence between voltage and frequency
according to the data mentioned on the
identification plate. Voltage differences from
+6% and –10 % are allowed.
Recommended minimum cross sections and maximum cable lengths
Mains voltage
10m cable
110V
1.5mm*
230V
1.5mm*
SWITCHING ON AND OFF
Switching on:
Plug motor into the power source
Set the in line circuit breaker
Press the on/off switch on motor
CHANGING GEARS
The machine is equipped with a mechanical two-speed
gearbox. Select the required speed by pressing-in,
shifting and engaging. The position of the lower speed
is in direction of the working spindle. Change the
Attention:
Never apply force when changing gear.
Change the gear only when the motor
is stopped.
Never use tools, such as hammers
or pliers to change the gear.
04
30m cable
2.5mm*
2.5mm*
Switching off:
speed only when the machine is not running,
and support the speed-changing by slightly rotating
the work spindle.
DANGER—SAFETY: Keep hands and other objects well clear of the mixing shaft and canister when mixer is in operation or serious injury could result.
The motor is made in protection class II.
Only use extension cables with a sufficient cross-
section. A cross-section which is too small could
lead to an excessive power loss and to an
overheating of motor and cable.
*Cross section in sq. mm
Release the on/off switch
This will trip the inline circuit breaker
eliminating accidental start-up
Speed
Unloaded
One
220RPM
Two
670RPM
Loaded
120RPM
410RPM
Publicidad
