Troubleshooting; Safety Notices - CASO DESIGN MCG30 Chef Manual Del Usuario

 Wipe the door, window and the door gaskets with a damp cloth, to remove any spatters
and spilt food. Residues on the door gasket can mean that the door does not close
properly any more, which will cause the microwaves to escape.
 Wipe off any steam, which has settled on the oven door, with a soft cloth. This may be
the case if the device is used in an extremely damp environment and is normal.
 Smells can be removed from the oven by mixing a cup of water with the juice and the
skin of a lemon, pouring this into a deep microwave-proof bowl and allowing it to cook
in Microwave mode for five minutes. Then, dry off the oven thoroughly with a soft cloth.
 After cleaning the interior space, leave the oven door open until the interior of the device
is completely dry.
 Front of device and operating panel
 Clean the front of the device and the operating panel with a soft, slightly damp cloth.
 Please bear in mind that the operating panel does not get wet. Use a soft, damp cloth
for cleaning.
► Leave the oven door open to prevent the device from being re-started accidentally.
Exterior housing

 Clean the exterior surfaces of the device with a damp cloth.
 Rotating plate and rolling ring
 The glass turntable must be removed and cleaned occasionally. Wash the plate in a
warm soapy solution or in the dishwasher.
 The rolling ring should be cleaned regularly to prevent excessive noise development or
a rotational malfunctions.
The rolling ring can be washed in a mild soapy solution or in the dishwasher. Please
remember to put the rolling ring back again properly after cleaning it.
 Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.

17 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

17.1 Safety notices

Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
Please note
76