Manual Code Entry; Automatic Code Search For Some Well-Known - Ebode TAKE 6IR+RF Guia Del Usuario

4.1. Manual code entry

Take your code book and search for the list matching the
equipment you are looking for, e.g. TV or DVR. Next, find
the relevant brand (e.g. Sony). Now you will find one or
more 4-digit codes. If there is more than one code, it
depends on your equipment which code is correct.
Generally, the codes are displayed in order of age of the
equipment. Older equipment first, younger equipment at
the end. Sometimes you will have to try several codes
before you find the right code for your equipment.
1. Make sure your equipment is switched on (for example
TV).
2. Press and hold the S (8) key until the LED indicator lights
continuously. Release the S key.
3. Press and release the mode key (4) of the device you
want to control (for example TV).
4. Enter the 4-digit code from the Code Book by using the
key pad (14). The LED (2) turns off after the last digit is
entered. If you entered a wrong code the LED blinks for 3
seconds and then goes off. You have to repeat from step
2.
5. Point the remote in the direction of your TV and press
the POWER button (1). Your device should turn off. Check
other functions (for example for a DVR FF or REW, etc.). If
certain functions are not responding, this indicates that
the entered code is not the correct one. In that case
repeat the above procedure with the next corresponding
code of your brand.
6. Repeat this procedure from step 1 for the other
equipment you want to control (DVR, DVD, STB,...). If your
equipment (TV, STB, etc....) does not respond, try the other
codes for your brand. If it still doesn't respond, try the
manual code search method (4.4 Manual code search).
4.2. Automatic code search for some well-known brands
If your brand is listed hereafter, you can use the brand
search method (faster than the "manual" and the
"automatic code search").
BRAND
Philips / Radiola
Akai / Daewoo /
JVC / Panasonic /
Sharp / Sony /
Toshiba
Brandt / Thomson
1. Turn on the device you want to control.
2. Press and hold S (8) until the LED indicator (2) lights
steadily. Release S button.
3. Press the mode button (4) that matches the equipment
you wish to control. The LED (2) blinks once.
4. Enter the code corresponding to your brand, point the
TAKE 6 Remote in the direction of your equipment, press
CHAN+ (6) once only. Continue to point the TAKE 6
Remote at your equipment until the equipment changes
Channel (the remote control sends an IR signal every
second. Please wait until your equipment reacts). When
your equipment does react, press on the key -/-- (13) to
confirm. If you accidentally miss the code, you can stop
13-3-2014
CODE
Telefunken /
1
Saba / Normende
2
3
7
BRAND
Grundig /
Blaupunkt
Nokia / ITT
ebode TAKE6 IR/RF
CODE
4
5
6