Chip Extraction; Saw Blade Selection; Saw Blade Change; Riving Knife/Splitter - Mafell KSS 60 cc Traducción Del Manual De Instrucciones Original

4.2 Chip extraction

Danger
Substances that are harmful to
health must be taken up with an M-
suction device.
Connect the machine to a suitable external dust
extractor during all work generating a considerable
amount of dust. The air velocity must be at least 20
m/s (65.6 ft / sec.).
The inside diameter of hose connector 1 (Fig. 3) is 35
mm (1 3/8 in.).

4.3 Saw blade selection

Use a sharp tool to obtain a good cut quality and
select a tool from the following list according to
material and application:
For cuts especially along the grain in soft or hard
wood:
- Circular saw blade carbide Ø 185 x 2.4 x 20 mm (7
9/32 x 3/32 x 51/64 in.), 16 teeth
For cuts along and across the grain in soft or
hard wood:
- Circular saw blade carbide Ø 185 x 2.4 x 20 mm (7
9/32 x 3/32 x 51/64 in.), 24 teeth
For cuts especially across the grain in soft or
hard wood:
- Circular saw blade carbide Ø 185 x 2.4 x 20 mm (7
9/32 x 3/32 x 51/64 in.), 32 teeth
For cuts especially across the grain in soft or
hard wood "fine cut":
- Circular saw blade carbide Ø 185 x 2.4 x 20 mm (7
9/32 x 3/32 x 51/64 in.), 56 teeth

4.4 Saw blade change

Danger
Pull the power plug during all
service work.

Press the push-button 2 (Fig. 2) and pull the
locking lever 3 (Fig. 2) upwards. Now the saw
shaft is locked in position and the gearshift lever
locked.

Using the Allen key 4 (brackets Fig. 3) release
the flange screw 5 (Fig. 3) counter clockwise.
Remove the screw and the front clamping flange
6 (Fig. 3).

Now you can remove the saw blade after
opening the retractable saw guard.

The clamping flanges must be free of adhering
parts.

Pay attention to the sense of rotation when
inserting the saw blade.

Afterwards, mount the clamping flange, attach
the flange screw and tighten it by clockwise
turning.

4.5 Riving knife/splitter

Danger
Pull the power plug during all
service work.
The riving knife 7 (Fig. 3) prevents the saw blade
from jamming during longitudinal cutting. The correct
distance to the saw blade is shown in (Fig. 4).

For adjustment purposes, release the screw 8
(Fig. 3) with the Allen key 4 that is included in
the supply (Fig. 3).

Adjust the riving knife/splitter by moving it in its
longitudinal groove and retighten the screw
afterwards.
5

Operation

5.1 Initial operation

Personnel entrusted to work with the machine must
be made aware of the operating instructions, calling
particular attention
instructions".

5.2 Switching on and off


Switching on: Press the switch-on lock 9 (Fig.
2) forward to unlock it. Then activate the switch
trigger 10 (Fig. 2) while keeping the switch-on
lock depressed.
As this is a switch without locking device, the
machine will only run for as long as this switch trigger
lever is pressed.
The built-in electronic system provides for jerk-free
acceleration when the machine is switched on and
under load readjusts the speed to the fixed setting.
-23-
to the chapter "Safety