Light; Cutting Depth Adjustment; Setting For Bevel Cuts; Setting For Mitre Cuts - Mafell KSS 60 cc Traducción Del Manual De Instrucciones Original

In addition, this electronic system adjusts the motor
down in case of overload, i.e. the saw blade will stop.
Switch the machine off then. Then switch the
machine on again and continue sawing at a reduced
feed speed.
The setting wheel 11 (Fig. 2) can be used to adjust
the saw blade speed in a continuously variable
manner between 2700 and 4700
Level
1
2
3
4
5
6
Material groups
- PVC, Plexi, PA
Level: 1 - 6
-
- Hardwood, softwood, plywood
Level: 4 - 6
-
- Coated panel materials
Level: 4 - 6
-
- Soft fibre
Level: 6
-

Switching off: For switching off, release the
switch trigger 10 (Fig. 2). The built-in automatic
brake limits the saw blade slowing time to
approx. 1 - 2 s. The switch-on lock automatically
takes effect again and secures the portable
circular saw against accidental switch-on.

5.3 Light

Caution
Do not stare into the burning lamp!
The power tool is equipped with a light module 21
(Fig. 5).
The light module is supplied with power for a certain
period of time as soon as the machine is switched on,
and is then ready for operation.
rpm.
Speed rpm
2700
3100
3500
3900
4300
4700
When the machine is ready for operation, the light
module automatically switches the light on when the
machine is moved or switches it off when the
machine is standing still for longer periods.

5.4 Cutting depth adjustment

The cutting depth is continuously variable between 0
and 66 mm (2.60 in.).
Proceed as follows to adjust it:

Unfasten the clamping lever 12 (Fig. 1).

Set the cutting depth with the plunge lever 13
(Fig. 1).

The set depth can be read off the scale 14 (Fig.
1). The bevelled edge of the plunge lever serves
as indicator.

Retighten the clamping lever 12 (Fig. 1).
Always set the cutting depth
approx. 2 to 5 mm (5/64 to 13/64
in.) larger than the material
thickness to be cut.

5.5 Setting for bevel cuts

For bevel cuts, the saw unit can be set to any angle
between 0 and 45°.

In order to incline it, bring the machine into
home position and support it such that it is
possible to tilt the saw unit.

Release the lever 15 (Fig. 1).

Adjust the angle according to the scale on the
segment for tilting.

Retighten the lever 15 (Fig. 1) afterwards.

5.6 Setting for mitre cuts


Release the limit stop 21 (Fig. 7) and adjust the
angle plate according to the scale on the guide
rail.

Afterwards retighten the limit stop.

Place the machine with the two stop bolts at the
bottom side of the guide rail against the
workpiece to be processed and carry out the cut
by pushing the machine forward.

After the cut, return the saw to its original
position by reversing.
-24-