Operation - Schulz Hidropo Manual De Instrucciones

8. OPERATION

Using the vacuum cleaner with solids (dust):
Always use fi lters when vacuuming solid particles (dust), otherwise you will damage your product.
Attach the hose to the side inlet opening on the dust compartment (Figure 8.1).
After use, clean it. It will extend the life span of your product.
Note: Check if the accessories are properly attached before using them.
Using with liquids:
Remove the fi lter when aspiration the liquids (model 1200W).
The aspirated liquid stays in the dust compartment. When the liquid reaches the maximum level, the vacuum
cleaner will stop sucking and you will notice a change in the noise emitted by the product. It happens because of
the sealing fl oat, which prevents the liquid from getting in contact with the motor.
Turn off the equipment immediately and unplug it from the power outlet.
Empty the dust compartment and proceed with cleaning again.
Before putting the vacuum cleaner away after using it with liquids, dry it off. Leaving water inside it will cause
gradual damage.
After aspiration the liquid, let the fi lter drying completely. Not aspire dust with fi lter wet (model 2000W).
ATTENTION
accidents.
Replacing fi lters:
A.
Release the side clips and lift the top lid by the
B.
Remove the fi lters;
C.
Fit a new fi lter in the place
D.
Place the top lid on the dust compartment again and lock the side
Never point the hose in the direction of people and animals. This might cause serious
(Figure 8.2 and 8.3);
FIGURE 8.1
handle;
clips.
26