Malfunctions; Transport And Storage; Technical Specifications - Tunturi E30L Manual Del Usuario

After exercising, clean the equipment with a soft,
absorbent cloth. Do not use solvents. Sweat may
cause corrosion: we recommend therefore that you
protect all metal surfaces outside the plastic covers
with teflon or car wax.
Never remove the equipment's protective casing.
The electromagnetic brake forms a magnetic field
that may damage the mechanism of a watch, or the
magnetic identification strip on a credit or cash card,
should they come into immediate contact with the
magnets. Never attempt to detach or remove the
electromagnetic brake!
The electromagnetic brake is based on
electromagnetic resistance; resistance level is
electronically measured and shown as watt reading
on the display. Due to the measurement system,
your Tunturi ergometer need not be re-calibrated
when assembled, serviced and used according to
this Owner's Manual.

MALFUNCTIONS

Despite continuous quality control, defects and
malfunctions caused by individual components
may occur in the equipment. In most cases it's
unnecessary to take the whole device in for repair,
as it's usually sufficient to replace the defective part.
If the equipment does not function properly during
use, contact your Tunturi dealer immediately.
Always give the model and serial number of your
equipment. Please state also the nature of the
problem, conditions of use and purchase date.
If you require spare parts, always give the model,
serial number of your equipment and the spare part
number for the part you need. The spare part list
is at the back of this manual. Use only spare parts
mentioned in the spare part list.

TRANSpORT AND STORAGE

Please follow these instructions when carrying and
moving the cycle about, because lifting it incorrectly
may strain your back or risk other accidents:
Always switch the power off and unplug the
NOTE!
power cord before you start moving the equipment
around!
Stand behind the equipment. Grip the seat with
one hand and the handlebar with the other, and set
your foot on the rear support. Tilt the equipment
so that it rests on its transport wheels. Wheel the
equipment to move it, on these transport wheels.
Lower the equipment while holding on to the
handlebar and remain behind the equipment all the
time. Transport the equipment with caution
NOTE!
over uneven surfaces, for example over a step. The
equipment should never be transported upstairs
using the wheels over the steps, instead it must be
carried. We recommend that you use a protective
base when transporting the equipment.
8
To prevent the equipment malfunctioning, store in
a dry place with as little temperature variation as
possible and protected from dust.

TECHNICAL SpECIFICATIONS

Length .................................................122 cm
Width ...................................................70 cm
Height ..................................................130 cm
Weight .................................................48 kg
This product meets the requirements of the EU's
EMC Directives on electromagnetic compatibility
(89/336/EEC) and electrical equipment designed for
use within certain voltage limits (73/23/EEC). This
product therefore carries the CE label.
This product meets EN precision and safety
standards (Class HA, EN-957, parts 1 and 5).
Due to our continuous policy of product
development, Tunturi reserves the right to change
specifications without notice.
The instructions must be followed carefully
NOTE!
in the assembly, use and maintenance of your
equipment. The warranty does not cover damage
due to negligence of the assembly, adjustment and
maintenance instructions described herein. Changes
or modifications not expressly approved by Tunturi
Oy Ltd will void the user's authority to operate the
equipment!
We wish you many enjoyable trainings with your
new Tunturi training partner!