Flex FX1171T Manual Del Operador página 11

b. Remove the battery pack and select the Drill
Position.
c. Rotate the chuck body counterclockwise, as
viewed from chuck end, to open the chuck to
approximately the bit diameter.
d. Insert a clean bit up to the drill-bit flutes for
small bits, or as far as it will go for large bits
(Fig. 3).
WARNING
chuck jaws. Do not insert the drill bit into the
chuck jaws at an angle and then tighten the
chuck as shown in Fig 5. This could cause the
drill bit to be thrown from the tool, resulting in
possibly serious personal injury or damage to
the chuck.
e. Close the chuck by rotating the chuck body
clockwise and securely tighten by hand
(Fig. 4).
To remove the bit:
a. Rotate the chuck body counterclockwise,
as viewed from the chuck end, to open the
chuck.
b. Remove the bit.
WARNING
protective gloves when removing the bit
from the tool, or first allow the bit to cool
down.
REMOVABLE BELT CLIP (FIG. 6)
Your tool is equipped with a removable belt clip
that can be positioned on the side of the tool for
convenient transportation.
Install the belt clip onto the tool:
a. Remove the battery pack from the tool.
b. Align the rib and the hole of the belt clip with
the opening and the threaded hole on the
base of the tool, respectively.
c. Insert the screw and securely tighten the
screw with a screwdriver (not included).
Remove the belt clip from the tool:
a. Remove the battery pack from the tool.
b. Use a screwdriver to loosen the screw that
attaches the belt clip to the impact wrench.
c. Remove the screw and the belt clip.
Make sure to insert the
drill bit straight into the
The bit may be hot after
prolonged use. Use
Fig. 4
Fig. 5
Fig. 6
Removable
Belt Clip
-11-
Opening
Rib