Flex FX1171T Manual Del Operador página 16

LED LIGHT (FIG. 14)
Your tool is equipped with an LED light, located
on the base of the tool. This provides additional
light on the surface of the work piece for
operation in lower-light areas.
The LED light will automatically turn on with a
slight squeeze on the variable-speed trigger
switch, before the tool starts running, and will
turn off approximately 10 seconds after the
variable-speed trigger switch is released.
The LED light will rapidly flash when the tool
and/or battery pack becomes overloaded or too
hot, and the internal sensors will turn the tool
off. Rest the tool for a while or place the tool
and battery pack separately under air flow to
cool them.
The LED light will flash more slowly to indicate
that the battery is at low-battery capacity.
Recharge the battery pack.
ANTI-KICKBACK
The anti-kickback feature enables better control
of the drill and improves user's comfort. The drill
automatically turns off in case of a sudden and
unexpected rotation of the drill.
To restart the drill, release the trigger switch and
then turn the drill back on.
TURBO MODE (FIG. 15)
In Turbo mode the tool delivers higher rotation
speed and higher RPM. The torque remains the
same.
NOTE: When operating in Turbo mode, the tool
depletes the battery pack faster.
NOTICE: The Turbo mode cannot be activated
or deactivated while the tool is in operation.
Press the Turbo button to activate the Turbo
mode of the tool. The indicator light will light up
at the same time. When you press the trigger
switch the tool will operate in Turbo mode.
To turn off the Turbo mode, release the trigger
switch, and then press the Turbo button. The
indicator light will turn off and the tool will return
to its "normal" mode.
Fig. 14
LED Work light
NOTICE: The tool is equipped with a reverse
protection function. When the drill rotates
quickly, it will automatically stop. This is not a
malfunction. This is a protection measure.
Fig. 15
Turbo Function
Indicator Light
Turbo Function
Button
-16-