How To Use - VOX electronics TM-6003 Manual De Usuario

SPEED KNOB
Fig.2

HOW TO USE

Before initial use
1. Before first use, unpack the appliance and place all parts on a horizontal surface.
2. The jar assembly (as Fig.1, including the measure cup, lid, seal ring, jar, assembly) has
cutter head
already been assembled into the motor unit. Disassemble to wash all detachable parts except the
motor unit. Please refer to the latter chapter CARE AND CLEANING.
3. Disassemble the grinding cup components (including grinding cup, seal ring, grinding cutter head
parts) and also the chopper components(including chopper, seal ring, chopping cutter head parts) (as
Fig.1A).Please refer to the latter chapter CARE AND CLEANING.
4. Once all pieces have been cleaned and dry thoroughly, reassemble them.
1) Invert the jar onto a level surface, holding the jar handle, put the seal ring and blade assembly
onto the jar base bottom and secure the cutter head assembly by turning it anti-clockwise up to
tightly （See Fig.3）
2) Re-position the jar assembly with its opening upwards, and then put the lid onto the jar assembly.
Place the measure cup exactly into the lid by aiming at a fixed position in the middle of the lid and
turning the cup clockwise up to tightly. （See Fig.4）
3) Finally, place the assembled jar onto the motor unit by adjusting well the connector at the bottom
of the jar, and tight it. (See Fig.5）
4) Assembly the grinding cup components- Place the grinding cup seal ring into grinding cutter head
components, and then buckle into the grinding cup. Please turn the cutter head components
anticlockwise until tightly to ensure it assembly in place.(See Fig.5A)
5) Assembly the chopper components-Place the grinding cup seal ring into chopping cutter head
components, and then buckle into the grinding cup. Please turn the cutter head components
anticlockwise until tightly to ensure it assembly in place(See Fig.5B).
Note:only one grinding cup, and it should be share used by grinding cutter head components
and chopping cutter head components.
When need to use grinding cup or chopper, please anticlockwise take out the jar from motor base
first(See Fig.5C), then place the grinding cup or chopper on the motor base and turn it anticlockwise
until tightly to ensure it was assembled in place.(See Fig.5D)
CAUSION: Jar and jar base is now secure. Do not try to twist the jar and jar base onto motor unit