Bosch Sensixx DS38 i-Temp Instrucciones De Uso página 22

Problem
Water flows through the
holes on the soleplate.
Dirt comes out through
the soleplate.
The iron does not
produce any steam.
The ironed garment turns
dark and/or sticks to the
soleplate.
The soleplate turns
brown.
The appliance makes a
pumping sound.
Loss of pressure during
ironing.
Water spots appear on
the garment during
ironing.
Water spots appear on
the garment during use
of the "PulseSteam"
function.
The hose gets hot during
use.
Water leakage from the
boiler.
The iron does not stop
steaming after placing it
on the pad (2).
If the above does not solve the problem, get in touch with our customer service.
22
B O SC H
Possible causes
1. The water is condensing inside the
pipes because steam is being used
for the first time or has not been
used for a long time.
1. There is a build up of scale or
minerals in the boiler and iron.
2. Chemical products or additives
have been used.
1. The boiler is not switched on or
the water tank is empty.
2. The water tank is not fitted onto
the housing correctly.
1. The selected temperature is too
high and has damaged the
garment.
1. This is a regular consequence of
continued use over a long period
of time.
1. Water is being pumped into the
steam tank.
2. The water tank is not fitted onto
the housing correctly.
3. The sound will not stop.
1. Steam release button has been
activated for too long a period of
time, that is, it has been pressed
too frequently.
1. May be caused by steam
condensed on the ironing board.
1. Water spots are caused by steam
condensation in the hose when
cooling down after use.
1. This is normal. It is caused by the
steam passing through the hose
during steam ironing.
1. Scale collector (12*) located at
the bottom of the appliance is
loose.
1. "PulseSteam" function has been
activated.
Solution
1. Point the iron away from the ironing area
and press the steam release button until
steam is produced.
1. Carry out a cleaning cycle (see
"Calc'nClean Perfect" section).
2. Never add products to the water.
Use tap water mixed 50% with distilled or
demineralised water. To prolong the
optimum steam function, mix tap water
with distilled water 1:1. If the tap water in
your area is very hard, mix tap water with
distilled water 1:2.
Clean the soleplate with a damp cloth.
1. Set the power button (10) to the "I"
position, and/or fill the water tank.
2. Fit the water tank back onto the hou sing
correctly.
1. Select a suitable temperature for the
material being ironed and clean the
soleplate with a damp cloth.
1. Clean the soleplate with a damp cloth.
1. This is normal.
2. Fit the water tank back onto the hou sing
correctly.
3. If the sound will not stop, do not use the
steam generator and contact an
authorised technical service centre.
1. Use the steam release button at
intervals. This improves the ironing result
as the textiles will be steamed, dried and
ironed properly.
1. Wipe the textile cover of the ironing
board, and iron any water drops to dry
them.
1. Water drops stop coming out of the
soleplate after using the "PulseSteam"
function for some time.
1. Place the hose on the opposite side so
that you cannot touch the hose during
ironing.
Tighten up the scale collector.
1. Just press the trigger once again and the
iron will stop steaming at once.
* Model dependent